Submissions

Submission Preparation Checklist

As part of the submission process, authors are required to check off their submission's compliance with all of the following items, and submissions may be returned to authors that do not adhere to these guidelines.

• The Editorial Team accepts scientific articles that correspond to the journal’s academic scope and have not been previously published in any other journals. Manuscripts must be submitted only through the journal website using the Open Journal System (OJS) online submission and peer-review platform. All materials should be submitted in electronic form in .doc or .docx format.
• The corresponding author is required to upload a cover letter via the OJS system when submitting the manuscript. The cover letter must confirm that the submitted manuscript has not been published previously, is not under consideration by another journal, and that the principles of academic integrity have been fully observed.
• The manuscript text must be prepared using Microsoft Word, with Times New Roman font, 12-point font size, and single line spacing. Page margins should be set as follows: top and bottom – 2 cm, left – 3 cm, right – 1 cm. The first-line indent of each paragraph should be 1 cm, and all pages must be numbered.
• Figures, tables, graphs, and photographs used in the article must be cited in the text at their first mention. Figures should be numbered consecutively and captioned below (e.g., Figure 1, Figure 2, Figure 3), while tables should be numbered and titled above (e.g., Table 1, Table 2, Table 3). A maximum of five (5) illustrations is allowed per article.
• The total length of the article, including the abstract, references, and notes, must be between 5,000 and 7,000 words. Manuscripts that do not comply with the specified technical and structural requirements will not be considered by the Editorial Board and will not be accepted for publication.